Abacus Car Alarm

206 Leigham Court Road, London Sw16 2RB
Tel: 0208 677 1999 ----- Mobile 07930 332 362

General Interest

Classic Japanese Motorcycles

Autowatch Programming

To enter the programming mode of the Autowatch alarm you will need the 5 digit override code supplied when the alarm was fitted. Without this number it will be impossible to program new remotes into the system.

To enter programing mode, wait for the alarm to immobilise itself.

Turn the ignition on, the LED will be constantly on, turn the ignition off, the LED will now flash, count the flashes for the first number in the override code. When the LED has flashed the amount of times that corresponds to the first number of the code turn the ignition switch on. Turn off the ignition and count the flashes for the next number in the code and so on until all the numbers in the override code have been entered. If the code has been recognised the LED will flash very quickly for a few seconds, you are now in programming mode and the alarm is also disarmed. If the LED has not flashed quickly - start again from the beginning

BACK