|
Abacus Car Alarms 206 Leigham Court Road, London Sw16 2RB
|
General Interest
Classic Japanese Motorcycles
1. Arm the alarm with a remote control
2. Turn the ignition on within 10seconds (confirmation beep)
3. Transmit 4 times with a remote control (4 boop’s as confirmation)
4. Turn the ignition off
5. Turn the ignition of and on to the corresponding number of the function
to be programmed (LED lit on, with
ignition on). Leave the ignition switched on.
6. Press the remote control once if you wish enable the function of the
first column (beep)
7. Press the remote control again if you wish enable the function of the
second column (boop).
8. Turn off the ignition and transmit with the remote control if you wish
finish the operation, otherwise turn the
ignition on again to the corresponding number of the function to be programmed
and so on.
|
Beep
|
Boop
|
|
1 Audible tones on arming and disarming *
|
No audible tones on arming and disarming
|
|
2 Direction indicators flash on arming and
disarming * |
No direction indicator flash, on arming and disarming
|
|
3 Horn command (wire 20)
|
Continuous horn output (wire 20) *
|
|
5 Passive arming engine immobilisation. *
|
Passive arming alarm and engine immobilisation.
|
|
6 Passive arming with movement sensor.
|
Passive arming without movement sensor enabled * |
|
7 Continuous alarm trigger *
|
Single alarm trigger.
|
* Factory standard feature
This page and all
its contents are Copyright© by : ABACUS CAR ALARMS