General Interest

Classic Japanese Motorcycles

Programming Remotes

Linking up Single Button Remotes

You will need one working remote to program a new remote into the system. This remote must be enabled by a dealer with a 16 digit code which is supplied on a plastic card, without this code it will be impossible to program a new remote into the alarm.

Programming single button systems

1 Arm and disarm the alarm sixteen times or until the alarm stops responding, alarm now in program mode.....

2 Once in program mode press the button of the new remotes(s), press the button of the original remote(s). This must be done within 8 seconds of each action. If 8 seconds pass without any actions the alarm will automatically exit programming mode and you will have to start from step 1.

3 Wait 8 seconds to exit learning mode.

4 Test remotes.

Programming HPA Remotes

You will need one working remote to program a new remote into the system. This remote must be enabled by a dealer with a 16 digit code which is supplied on a plastic card, without this code the alarm brain will have to be sent back to be reprogrammed.

1 Arm and disarm the HPA sixteen times or until the unit stops responding. You will hear 2 high pitched beeps followed by 2 low beeps (normal siren), or 2 high beeps followed by 4 low.

2 Within ten seconds turn on the ignition

3 Press button A on new remote -LED turns on.

4 Press button B on new remote -LED turns off and siren beeps once to confirm a successful link up.

5 Repeat 3 and 4 for all other remotes

6 When finished programming new remotes switch off ignition the siren will beep a number of times.

7 Check all remotes are programmed into the system.