Abacus Car Alarms

General Interest

Classic Japanese Motorcycles

Meta SR2 Targa Easy Fit Parking Sensors & SR2 TGi towbar friendly version + the New four sensor FrontPlate4 (see below)

Buy The Targa SR2 Online

Buy The Targa SR2 TGI Online (Tow bar friendly)

Buy The Frontplate 4 Online

Meta Parking Sensors Spare Parts

Avoid this...

And these...

and even this...

Fit this

Mounted directly onto the rear bumper, this ingenious device detects obstacles to the rear of the vehicle making parking safer and easier. Especially useful for longer vehicles or vehicles with restricted rear vision. As the vehicle reverses towards an obstacle, an audible warning beep increases intensity to alert the driver until a constant tone gives the indication to stop before contact.

This must be the easiest to fit reversing aid on the market. No large holes to drill, just simply remove the number plate, mount the number plate bracket and clip the number plate back into the bracket.

Please note: Only suitable for European oblong type number plates and not the square types fitted to some Japanese Gray import vehicles. Also the number plate must be centrally fitted to the vehicle and not to one side.

• Easy two wire installation
• In most cases installation takes less than an hour
• Adjustable sensitivity
• Adjustable speaker volume
• Offset adjustability (how close an object is)
• Range from 0.3 to 1.5 Metres
• Easy two wire fitment
• No large holes to drill
• No painting/respraying
• Very discreet
• Front or rear mounting (a separate on/off switch may be required for front mounting - not required for frontplate4, see below)

Meta SR2 area coverage compared with a 4 bumber sensor kit

Minature sounder can be hidden almost anywhere

RATING

Auto Express Review

FITTING INSTRUCTIONS

Buy The Targa SR2 Online

Buy The Targa SR2 TGI Online (Tow bar friendly)

Buy The Frontplate 4 Online

Meta FrontPlate 4

Specifically designed for front numberplate mounting, the FrontPlate4 system incorporates new 4 sensor technology for extended obstacle detection.

Mounted directly onto the front bumper, this ingenious device detects obstacles to the front of the vehicle making parking/manoeuvring safer and easier. Especially useful for vehicles with long sloping bonnets. Once the vehicle reverse gear is selected the FrontPlate4 is activated and will operate for approximately 20 seconds when another gear is used, everytime reverse is selected the timer restarts. As the vehicle moves towards an obstacle, an audible warning beep increases intensity to alert the driver until a constant tone gives the indication to stop before contact. More Info/Buy Online

Add Visual Display to SR2 RTG & Display4 parking sensor kits

Add on LED display unit for the Meta SR2 RTG & FrontPlate4 parking systems (Not SR2), adds visual warnig to the standard sounder. Simple plug & play fitting.

This Display unit will not function with the standard SR2 system.

BLUE: Obstacle detected, sounder does not bleep - more than 110cm approx
GREEN: Obstacle detected, sounder bleeps slowly - less than 110cm approx
YELLOW: Obstacle detected, sounder bleeps quickly - less than 65cm approx
RED: Obstacle detected, sounder bleeps continuously - obstacle in the offset area less than 12cm

Buy Online

Fitting Manual

RATING
Click on above logo for a comparison test report

Auto Express Review

SIMPLE FITTING

Remove number plate

Fit the Meta backing plate with the sensors

Clip number plate into the Meta backing plate

Connect the sensors to the control box, connect one wire to earth the other to the reversing light circuit. Connect the supplied speaker, adjust the sensitivity and speaker volume and that's it, finished.

Click here for all Meta Easyfit parking sensors

As mentioned in the 'In Gear' supplement from The Sunday Times, May 2007
Courtesy of The Sunday Times