For eight digit coded fobs (numbers ending with TC1B) click here
The 16 digit code is made up of numbers & letters which can only be: A,B,C,D,E & F, any other letters are not allowed and the code will be incorrect (known as a hexadecimal number). The 1 to 7 numbers refer to the available positions allowed for the remotes to be programmed, which means the alarm can be programmed with up to 7 remotes. Be care full when reading the code, Meta use a very poor font which makes it difficult to distinguish between the letter B and the number 8 and the letter D and the number 0. If in doubt try scanning the card at a high resolution and enlarging the image using your regular paint program.
Click For Programming Instructions
Please add the 16 digit code number to the comments box at checkout.
Complete with programming instructions
Please Note this fob is designed to work with UK/Ireland supplied Meta Alarm systems which use the 433Mhz frequency for communication between fobs and alarm systems, as such may not work with equivalent devices supplied to other parts of the World, we offer no guarantee that they will work with these products. This remote fob will not work with Meta devices supplied to either Belgium or Holland unless the alarm frequency is 433Mhz. We offer no refund should the remote fobs not function correctly with non UK/Ireland supplied alarm systems you buy at your own risk. If you are unsure about the frequency of your alarm system locate the alarm control unit (usually hidden somewhere under the dash) where on most boxes will be a sticker with the frequency printed (see photo below)
We can now supply Fobs for Holland, Belguim & other countries that use the 315Mhz frequency - More Info
Please add the 16 digit code to the comments box on the checkout page.
| I do not have the 16 digit code number if I send you my old fob can you make a copy?
||Sorry this cannot be done, we can only re-code the complete alarm ECU, see here
|The switch on my fob has broken off the circuit board, can you repair it?
||Sorry we do not have the parts or the skills to micro solder on a replacement switch